Monster Home | 90-97 | 99-05 | 06-Up | Monster Site

Bishop's 500 HP MONSTER | Monster's For Sale

SOLD

THE MIATA: 1990 Mazda Miata, 113,000km, Red with Black Interior and Black Top, power steering, Optional Hard Top Available @ $2500.00 extra.
 
MONSTER ENGINE: Ford 302 cu.in. 5.0L V8 engine. Inspected and completely prepared for this conversion.Ford GT-40, Monster Aluminum Radiator, 1 5/8 Thermal Coated Shortly Headers with stainless steel dual exhaust with cross over, K&N High Flow Air filter, Polished Valve Covers, new water pump, new alternator, new starter, power steering, completely serviced and ready for the street for dialing driving. Approx HP would be about 245hp.

SERVICED: Brakes (pads and fluid), Engine (Fresh oil, Sensors, Plugs, Heavy Duty Plug Wires, Anti-Freeze, filters and belts), Clutch Fluids, Transmission Fluid, Rear End Bearings and Fluid, Fuel Filter, When we perform the Monster conversion, a part of the car does not go untouched. Either by a direct result of our conversion or it is inspected to be good. When you are stuffing all that power in a mild manner little Miata, you got to make sure everything is right before you hit the streets.
 
TRANSMISSION: Tremic T-5 5-Speed Transmission (inspected and serviced) with new clutch, new clutch cylinder and stainless braided clutch line
 
REAR END: Ford Thunderbird 7.5” Rear End (inspected and serviced), 3:27 Gears.
 
WHEELS & TIRES: American Racing Shelby Razors finished in silver with polished lip 16” x 7”. Tires are Avon Tech M500 with 215/50/R16 front and 245/16/16 rear.
 
MONSTER CONVERSION: included modified K-member, modified oil pan, aluminum radiator, clutch master cylinder, clutch hose with fittings, clutch mast cylinder adapter, custom front & rear springs, manual transmission hanger, transmission mount, engine block mounts, differential hanger, firewall plates, radiator hanger with mounts, shifter adapter, sway bar mounts, differential torque mount plate, custom drive shaft, throttle cable ball receiver, custom coolant filler neck, modified hubs, custom axles with spacers, US washer bottle, cooling fans with hardware, clutch slave bracket, 1 5/8 inch thermal coated headers and installation manual.

VEHICLE CONDITION: We start with a good Miata for all our conversions and this one was excellent. Good black top and back plastic back window (not original), interior shows it mileage wear but is clean and un damaged. The exterior has a few minor door dings but other wise shows to be good. While doing the conversion we found not structural damage or "surprises" on it's belly. A good clean Miata.

KIT CONTENTS
1-5/8 inch custom thermal coated headers  
 Aluminum radiator with cooling fans and hardware
Radiator hangers and header
Clutch master cylinder  
Clutch hose & fittings  
Clutch master cylinder adapter  
Custom front springs
Canadian cars modified windshield washer fluid bottle
Transmission hanger and mount  
Block mounts  
Differential hanger and rear carrier braces
Firewall plates and templates
Shift adapter with rubber tunnel boot
Front Sway bar mounts  
Differential torque mount  
Throttle cable ball receiver  
Custom coolant fill neck  
Assorted wire, connectors & fasteners  
Instruction manual
Modified oil pan
Modified hubs
Custom axles and spacers
Engine mounts  
Clutch slave bracket  
Modified sub frame

Optional Parts on this Monster
Ford 302 cu.in.
High Flow Air Intake
Ford T-5 5-Speed Transmission
Thunderbird 7.5" IRS Differential - Services with new bearings and seals, high performance fluidser
Dual Exhaust with Flowmaster Muffler
New Fluids - Brake, Oil, Transmission, Anti-Freeze, Rear End, Clutch Slave and more.
All new filters - Oil, Air, and Fuel.
New Tires and Wheels
Fully services and ready for the streets!

February 10 2009: ANOTHER MONSTER FOR ADOPTION!

Well, the black beast is up for sale and available for adoption! Time for a new project and time for our little pride and joy to find a new home.

Check out the details here...

Have any questions about parts, kits, or products available from Bishop are welcome. Contact the us by phone and leave a message at 604-984-3673 or e-mail by visiting our contact page and we will respond promptly. Our office hours are Monday to Friday from 10:00am to 4:00pm PST. We really love to share the fun with other performance enthusiasts who want to take their cars to the next level of performance, appearance and handling! Thanks for visiting!

Complete suppliers of automotive superchargers, custom, racing and performance parts!

Home | Contact | Back | Top